BMW Enet Adapter Wifi Wireless for ALL BMW F/G/I-Series

The Enet WiFi Adapter for the BMW F/G/I series and Toyota Supra model. The ultimate adapter for the F/G series and Supra! This adapter is 10x faster than a standard K+Dcan cable and 2.5x faster than the orange MHD e-series Wifi adapter. (Attention: The Enet WiFi adapter can not be used on BMW E-Series cars!)

The Enet Wlan wireless adapter allows you to reliably use all Bimmer Apps' features on the go, faster and easier than ever before. Just plug it into the OBDII port, pair your mobile device to the Wifi access point created by the adapter, and you can flash, log, read codes, etc. instantly – no cable needed anymore.

While using the Autodiag Enet WiFi adapters your phone LTE/4G data connectivity and Bluetooth all remain active - and charging the phone is possible.

This Enet WiFi adapter supports the BMW F /G/ I series diagnostic and single module coding and programming by working with different kinds of software or bimmer mobile apps.

Besides Using the BMW ENET cable, the Enet WiFi adapter also works perfectly with the BMW F/G/I series with the latest ESYS 3.35.3 EsysPlus3.8.

◆ Embedded UART-ETH-WIFI module
◆ DC/DC converter for improved power consumption
◆ With additional CPU heat sink for over-temperature protection
◆ 2.4GHz 802.11b/g/n, compatible, default password 12345678
◆ Support IEEE 802.3、IEEE 802.3u
◆ WiFi Client/AP/Router Mode
◆ Support WPS/wds
◆ The range of baud rate: 1200~500000bps
◆ Support transparent transmission mode
◆ Support multiple security authentication mechanisms: WEP64/WEP128/ TKIP/ AES, WEP/WPA-PSK/WPA2-PSK 

◆ Support wireless roaming
◆ Support multiple network protocols: PPPOE/TCP/UDP/DNS/DHCP/DNS/HTTP/Firewire
◆ Support AT+ instruction set

BMW Enet Wifi adapter connection manual:
1. Plugin the adapter into the OBD port in the footwell on the driver' s side of the car.
2. Enable the Airplane mode on the iOS device.
Turn off Bluetooth on the iOS device.
Turn on Wi-Fi on the iOS device.
3. Disable CarPlay in the iOS settings ("Settings" > "General" > "CarPlay" > Select car > Disable "CarPlay").
4. Open the iOS Wi-Fi settings and connect to the adapter network.
5. Keep the distance between the iOS device and the adapter 5-30Meters distance.
6. Open the settings in the BMW Apps and make sure the correct adapter type is selected.
Tap "Connect" on the start screen in a variety of apps Enjoy!

               

 

The Enet Wifi adapter works with  BMWAiCoder, BimmerCode, BimmerLink, MHD, THOR, Xdelete, xHP, Protools, MG Flasher,  DEEPOBD, BootMod3 etc. More to be compatible!

The wireless adapter allows you to reliably use all popular App features on the go, faster and easier than ever before. Just plug it into the OBDII port, pair your mobile device to the Wifi access point created by the adapter, and you can flash, log, read codes, etc. instantly – no cable needed anymore.

While using the wireless adapters your phone LTE/4G data connectivity and Bluetooth all remain active – and charging the phone is possible.

Disclaimer

BMW and MINI are registered trademarks of Bayerische Motoren Werke AG. The X-Bimmer Tool is not affiliated with BMW AG in any way and is not authorized by BMW AG to act as an official distributor or representative. We are Independent BMW geeks and not part of BMW AG in any way.