Auto control presence occupancy sensors for lighting,led lamp pir movement sensor switch,presence detection sensor BS033C for Guangdong, China

Auto control presence occupancy sensors for lighting,led lamp pir movement sensor switch,presence detection sensor BS033C is created with fashionable design idea. We pride ourselves on our personalized and efficient service. For product inquiries, technical support, and other questions, you can reach us in any way stated on our 'Contact Us' page.

Auto control presence occupancy sensors for lighting,led lamp pir movement sensor switch,presence detection sensor BS033C

Welcome to use  occupancy sensors for lightingBS033C!

Noted: This product only works in the dusk or evening when the ambient light is less than 20 LUX or no any light in the surrounding environment.

occupancy sensors for lighting Instruction

The product adopts good sensitivity detector, integrated circuit. It gathers automatism, convenient safe, saving-energy and practical functions. It utilizes the infrared energy from human as control-signal source, it can start the load at once when one enters detection field. It can identify day and night automatically. It is easy to install.

occupancy sensors for lighting  SPECIFICATION:

occupancy sensors for lighting  FUNCTION:

• It can only work in the ambient light less than 20LUX (dark).
• Time-delay is added continually: When it receives the second induction signals after the first induction, it will compute time once more on the rest of the first time-delay basic (set time).
• Time-delay adjustment: It can be set according to the consumer’s desire. The minimum time is 10sec±3sec. The maximum is 7min±2min.
• The switch: The switch is “ON”,“OFF”,“AUTO”.

occupancy sensors for lighting  INSTALLATION: (see the diagram)

• Shut off the power.
• Loosen the connection column on the bottom of sensor, plug the wire into connection hole, tighten the screws; unload the surface of sensor, connect the sensor into connection box.
• Cross the installation screws into installation hole of sensor, aimed at the hole of connection box, tighten the screws, cover the surface of sensor.
• Switch on the ower then test it.

CONNECTION-WIRE DIAGRAM

occupancy sensors for lighting TEST:

• Set the function switch to “ON”, turn the TIME knob anti-clockwise on the minimum after taking the board-face off.
• Switch on the power, the lamp should be on;
• Set the function switch to “OFF”, the lamp should be off immediately, all functions should be in “stop” state.
• Set the function switch to “AUTO”,  after 30sec later, it enter into working position, the lamp will be turned on after receiving the inductor signal. Under no inductor signal condition, the lamp should be off within 5~10sec, the lamp should be on again after 5sec.